Step-by-step instructions

 

Before you start

Your UDisplay package includes the following:

  • Decorative Awards Display
  • Hook panel with standoffs
  • Installation Hardware

​Tools Required for Installation:

  1. Phillips-Head Screwdriver or Drill
  2. Level
  3. Pencil
Step 1

Locate an area for your UDisplay; check to make sure sufficient wall space is available by holding your hook panel against the wall.

Step 2

Unscrew the stand off caps. Level the hook panel against hte wall in desired location using a level.  Push one of the screws profided through the pre-drilled holes and mark the wall to indicate where to install anchors. 

Step 3

Install the anchors provided as necessary. (if installing onto wall studs, anchors are not needed, however you will need to use a longer screw, which is not provided)

Step 4

Using the screws and standoffs provided, pass each screw into each of teh standoffs and into the hanger board at the hole locations. Place hook panel onto the marked lcoations using the screws coming out the back of the board as you guide to connect to anchors.

Step 5

Using your drill/phillip screwdriver, tighten but DO NOT OVER TIGHTEN screws to wall.  Align UDisplay onto standoffs and screw in standoff caps.

Step 6 (optional)

Additional acrylic shelf installs on top of panel.